Leeson 1 HP C-Face Stainless Steel Boat Lift Motor

$534.00

Shipping calculated at checkout

Sold Out

About this Item

  • C-Face Mount (Direct Drive Style)
  • NEMA Enclosure
  • UL Listed
  • CSA Approved
  • TENV Housing

The Leeson/EG 1 HP Stainless Steel C-Face Boat Lift Motor is a NEMA motor that is UL Listed and CSA approved. Totally enclosed, non-venting housing (TENV). The housing helps prevent dirt and insects from getting into the motor. The motor is a standard duty, single-phase with a start capacitor. The c-face mounting style fits direct input face mounts. Fits direct drive systems like the BH-USA A-Drive Direct Drive Systems, Golden Sea Drives, and other direct drive input faces. Easy to follow wiring diagrams included with the motor. Made by Leeson Motors. It does not work on flat-plate belt-driven boat hoists.

Motor only wired 220 volts from the factory. Rewirable to 110 volts. Motor only doesn’t include GFCI wire harness or boat lift switch. Wired motors include a GFCI wire harness, a boat lift switch in the desired style of the switch, and cable length selected.

BH-USA recommends using a licensed electrician to wire or rewire any electrical components.

What is a C-Face Motor?

A “CFace” motor is a common American mechanical standard. Designed with a rugged flange on the face of the motor for mounting purposes. The weight of the motor is supported by the flange. Most commonly attached to a gearbox. The flange is strong enough to cantilever the motor.

The NEMA C-Face mount incorporates a machined-face flange and a pilot on the end of the shaft to allow direct-coupling with equipment. Bolts pass from the mounting-face through threaded-holes in the motor.

Specifications

Model #: C6C17NC109 A Max Run Time: 15 Minutes
Dimensions: 8" x 10" x 6 1/2" Weight: 33 lbs.
Catalog #: N/A SKU #: N/A
Horsepower: 1 Mounting Type: C
RPM: 1725 Service Factor: 1.15
Voltage: 115 / 230 Phase: 1/60
Amps: 13.8 (110) / 6.9 (220) SFtartA: 17.5 (110) / 8.25 (220)
Herz: 60 AMB: 40c
Frame: 56C HSG: TENV
Code: K Insulation: F
Shaft Diameter 5/8"